19
Miditherm MP
Care
Only use dry or slightly moist cloths for external
cleaning.
If necessary, sweep out or vacuum-clean the cooled-
down mould chamber.
To burn residues of modelling materials, heat up the
empty furnace to 1050°C regularly every 4 weeks and
maintain this temperature for 60 minutes. This is par-
ticularly necessary if the furnace is used exclusively at
700°C.
Always use the ceramic base.
Place the moulds in the chamber without touching the
walls as far as possible.
• Switch off the unit and pull out the plug prior to
any care, cleaning or maintenance work.
• Let the unit cool down until warm to the touch
prior to any care, cleaning or maintenance work.
• Do not spray the unit with water or immerse in
water.
To Next Page
Loading...