Setting up P16
1. Setup the P16 outputs by pressing the ROUTING button and paging over to “P16 Out”.
2. Select an output channel and then select a signal source.
3. By default, direct outputs from channels 1-16 are assigned.
4. If you are working with more than 16 channels, you can utilize any of your 16 mix busses to create sub-groups which can
also be assigned to P16 channels.
5. Other potential sources: Main LRC, Matrix Mixers, Monitor Bus, AUX & FX Return Direct Out, and Talkback.
To Next Page
Loading...
