Service Menu
3.5.3 CopyProjecttoUSB
The iX Developer project and all the files needed to run the application are copied
to an external USB flash drive or other USB connected storage device. Make sure
that the storage device is connected before try i ng this option.
3.5.4 DeleteProject
The iX Developer project and all its corresponding files are deleted from the
operator panel. There is no way of undeletingaproject,makesurethattheproject
should be deleted before confirming the deletion.
3.5.5 RestorePaneltoPreviousImage
The operator panel image can be restored to the panel image version the operator
panel was using before a new panel image was loaded into the operator panel. This
option is used to restore a panel to a known working condition.
3.5.6 RestorePaneltoFactoryImage
The operator panel image c
an be restored to the panel image version that the
operator panel was shipp
ed with from the factory. Use this option if all else fails,
this will downgrade the o
perator panel to its initial state.
3.6 SelfTest
The self test screen looks a little different depending on operator panel type.
To be able to fully
test the Carrier unit, a complete set of test plugs, SD-card and a
USB flash drive is
needed.
BeijerElectronics, MAEN352
10
To Next Page
Loading...
Need help?
General