Important Before using your cooker ALWAYS make sure that the timer has
been set to MANUAL operation. Unless this is done, the bottom oven
cannot heat up. Before seeking assistance make sure this is done
(refer to oven timer operation).
Oven Rotate the control knob in either direction until the control knob aligns
Multifunction with the required function symbol. Many of the functions will also
Selectors require the oven thermostat to be set before the oven will heat up.
Oven This is used in addition to the multifunction selector. This is used
Thermostat for all functions except defrost and lights only.
Turn the control clockwise to set the oven thermostat to the required
temperature.
If the timer is set correctly and the selector switch set to a suitable
function an indicator light will illuminate. This will remain on until
the oven reaches the required temperature. This light will then cycle
on and off as the thermostat maintains control of the oven
temperature.
Cooling Fan A gentle flow of air will be blown below the control panel when any
function (except ‘fan only’ and ‘light only’) is used. In some instances this
will continue after switching off.
This helps to keep the control panel and knobs cool.
After use ALWAYS return the controls to their off ‘O’ position.
Note In some instances, if thermostat is operated before the selector switch
the neon will be illuminated. This is not a fault and no elements will be on.
The Controls
11
Bottom Oven
selector
Bottom Oven
thermostat
Bottom Oven
Neon
Top Oven
Neon
Top Oven
thermostat
Top Oven
selector
Timer
To Next Page
Loading...
