Care and Cleaning
34
It is advisable to clean the decorative trims regularly to prevent
any build up of soiling which may detract from the appearance of
the Cooker. The recommended method of cleaning is to wipe
over the trims with a soft cloth wrung out in warm water, or mild non-
abrasive cleaner. (If in doubt try the cleaner on a small area of trim
which is not noticeable in normal use), then after wiping with a
cloth wrung out in clear water, dry with a soft clean cloth.
Regularly wipe with a clean, damp cloth and polish with a clean, dry cloth.
Open the door fully. The glass panel may now be washed. Stubborn
stains can be removed by using a well soaped fine steel wool soap pad.
Do not use scouring pads or abrasive powder, which will scratch the
glass
.
TURN OFF THE COOKER ELECTRICITY SUPPLY AND ALLOW THE
APPLIANCE TO COOL BEFORE REMOVING THE LAMP LENS. THIS WILL
AVOID THE POSSIBILITY OF ELECTRIC SHOCK.
Open the oven door and remove the oven shelves. Using a thick cloth,
grip the lamp lens, unscrew anti-clockwise and remove the lens.
Carefully unscrew the bulb anti-clockwise. Fit a replacement (15W 300˚C
SES) bulb and refit the lamp lens.
TURN OFF THE COOKER ELECTRICITY SUPPLY AND ALLOW THE
APPLIANCE TO COOL BEFORE REMOVING THE LAMP LENS. THIS WILL
AVOID THE POSSIBILITY OF ELECTRIC SHOCK.
Oven lamps are not covered by the guarantee. A new lamp may be
obtained from our parts department by calling 01709 579907
Open the oven door and remove the oven shelves. Using a thick cloth,
grip the lamp lens, unscrew anti-clockwise and remove.
Clean with a non-abrasive cleaning cream and refit the lamp lens.
Do not use scouring pads or abrasive powder, which will scratch the glass
lens.
Decorative Trims
and Control Panel
Replacement of the
Oven Lamp
How to Clean the
Lamp Lens
Control Panel and
Door Trims
Inner Door Panels
and Glass
To Next Page
Loading...
