18
Installation
Preparing the worktop cut out
To avoid danger or damage to the appliance, do not attempt to disassemble the appliance or replace
parts yourself. Always request a service visit.
Make a cut-out in the worktop according to the dimensions shown in the table.
For the purpose of installation and use, a minimum of 5cm space shall be preserved around the hole.
Be sure the thickness of the work surface is at least 30mm. Please ensure the worktop is made of
heat-resistant material to prevent deformations caused by heat from the appliance.
A(mm) B(mm) C(mm) D(mm) E(mm) F(mm)
268+4
-0
500+4
-0
50mini 50mini 50mini 50mini
Ensure that the induction hob is well-ventilated and that the air inlet and outlets are not blocked. Make
sure that the hob is not damaged in any way. Do not install a damaged hob.
Note: The safety distance between the hotplate and the cupboard above the hotplate should be at least
760mm.
To Next Page
Loading...
