Belling IHT603 - Using the Boost Function

11
Using the Boost function
To activate
1. First select the relevant heating zone by touching the relevant
heating zone selection key.
2. Touch the power boost control key. The zone indicator display
shows ‘P’ and the zone works on maximum power.
To cancel
1. If you wish to cancel the boost function before this, select the
relevant heating zone by touching the relevant heating zone
selection key.
2. Touch the power boost control key or the “-” button to cancel the
power boost function. The zone will revert to the on-going power
level.
3T
    T    󰀨
and the boost function will be automatically cancelled.
• The power boost function is available to all 4 cooking zones, however you cannot boost all 4
cooking zones at the same time. You can only boost one zone from each pair at the same time.
• The power boost function is automatically cancelled after about 5 minutes, and the zone reverts
to the ongoing power level.
• If no on-going power level was set prior to activating the power boost function, then the zone will
revert to power level 9 when the power boost function comes to an end.
• The power boost function involves one zone ‘borrowing’ some power from the adjacent zone.
Therefore, if zone 2 (the back-left zone) is on power boost, zone 1 (the front-left zone) can only
be used up to power level 7.
• If the front-left zone is on power boost, the back-left zone can only be used up to power level 7.
OR