Bender RCMA421H - 2 Safety Instructions; General Safety Instructions; Work Activities on Electrical Installations

7
RCMA421H_D00069_00_M_XXEN/05.2014
2. Safety instructions
2.1 General safety instructions
In addition to these operating instructions, the "Important safety instructions
for Bender products“, which are also included in the scope of supply, are an in-
tegral part of the device documentation.
2.2 Work activities on electrical installations
 Only skilled persons are permitted to carry out the work necessary to
install, commission and run a device or system.
 Compliance with applicable regulations governing work on electrical
installations, and with the regulations derived from and associated
with them, is mandatory. EN 50110 is of particular importance in this
regard.
 If the device is being used in a location outside the Federal Republic of
Germany, the applicable local standards and regulations must be com-
plied with. European standard EN 50110 can be used as a guide.
Failure to carry out work on electrical installations prop-
erly and correctly can put life and limb at risk!