Need help?Do you have a question about the Bender ISOMETER iso685 Series and is the answer not in the manual?
General| Type | Insulation monitoring device |
|---|---|
| Protection Class | IP20 |
| Automatic Adaptation to System Leakage Capacitance | Yes |
| Connection Monitoring | Yes |
| Automatic Device Self Test | Yes |
| Graphical LC Display | Yes |
| RS-485 Interface | Yes |
| Push-wire Terminal Connection | Yes |
| Output Relays | 2 changeover contacts |
| Operating Temperature | 55 °C |
| Storage Temperature | -40 °C...+70 °C |
| Communication Interface | RS-485 |
| Supply Voltage | AC 100...240 V / DC 24...240 V |
Explains how to attach the device to a standard DIN rail.
Describes the method for mounting the device using screws.
Outlines different device versions without a display or controls.
Explains the function of each terminal connection on the device.
Details the function of control panel buttons during setup.
Lists reasons why the device might signal an alarm or error.
Explains the procedure to clear alarm notifications.
Lists the default values for response values and other parameters.
To Next Page
