Bender RCMA423 Operating Manual

Technical data
36
TGH1442en/06.2012
6.4 Error codes
Should, contrary to all expectations, a device error occur, error codes will ap-
pear on the display. Typical error codes are described below:
Error code Meaning:
E.01
Fault CT connection monitoring
Appropriate action:
Check CT connection for short-circuit or inter-
ruption. After eliminating the fault, the error
code will be automatically deleted.
E.02
Fault CT connection monitoring
during manual self test.
Appropriate action:
Check CT connection for short-circuit or inter-
ruption. After eliminating the fault, the error
code will be automatically deleted.
E....
Appropriate action when error codes > 02
occur:
Appropriate action:
Carry out a reset. Reset the device to factory
setting. After eliminating the fault, the error
code will be automatically deleted.
If the fault continues to exist, please contact the
Bender Service.

Bender RCMA423 Specifications

General

Brand	Bender
Model	RCMA423
Category	Measuring Instruments
Language	English