RBJ Series of Rolling Bridge Jacks 20 P/N 5900004 — June 2018 — Rev. C2
2. When the Rolling Bridge Jack reaches the desired height, release the PUMP end, then press and
hold the RELEASE end to lower the Rolling Bridge Jack onto the closest Safety Lock.
3. Release the RELEASE end of the pump when the Jack settles on the Safety Lock.
This drawing shows the Jack on a Safety Lock; the Safety is help in place on the Safety Lock Pin
by the weight of the Rolling Bridge Jack and the vehicle on it.
⚠ WARNING Only leave your Rolling Bridge Jack on a Safety Lock or fully lowered.
4. To lower the Rolling Bridge Jack from a Safety Lock: press the PUMP end of the pedal to get it off
the Safety Lock Pin, pull the Safety Handle up to move it out of the way, then press and hold the
RELEASE end of the pedal.
The Rolling Bridge Jack begins lowering.
5. When the Jack is fully lowered, release the RELEASE end of the pedal.
Assuming the test went fine, your Rolling Bridge Jack is ready for normal operation.
If there were issues, resolve the issues before beginning normal operation. You can refer to
Troubleshooting for additional information.
To Next Page
Loading...
