XPR-10 Series Two-Post Lifts 70 P/N 5900951 — Rev. D — May 2019
Lowering a Vehicle
To lower a Vehicle off the Lift, you first raise it a small amount to get it off its Safety Locks, then lower
it.
To lower a Vehicle off the Lift:
1. Check under and around the Vehicle to make sure the area is clear of all obstructions.
If you find any obstructions, move them out of the way.
2. Press and hold the Up Button for a second or two to move the Lift off its Safety Locks.
Raise the Lift at least two inches to get clear of the Safety Locks.
3. Push and hold the Safety Lock Release Handle (on the Powerside Post above and to the right of
the Power Unit).
4. Push and hold the Lowering Handle (on the front of the Power Unit).
Important: Both the Safety Lock Release Handle
and
the Lowering Handle must be held down
at the same time to lower the Lift.
The Lift begins lowering.
⚠ WARNING: Do not override the Lift controls; for safety purposes, they are designed to stop the
Lift if released. Overriding the Lift controls could lead to damage to the Lift, damage
to the Vehicle on the Lift, or injury (even death) to persons near the Lift.
Remain clear of the Lift as it comes down; obey the pinch point warning decals.
5. When the Lift is on the ground, release both Handles, then move all four Lift Arms to their full drive-
through positions.
6. Drive the Vehicle out.
To Next Page
Loading...
Need help?
General
