XPR-9 Series Two-Post Lifts 10 P/N 5900371 — Rev. D2 — May 2023
XPR-9 Series Lift components include:
• Power Side Post: The Power Side Post holds the Power Unit, the Safety Lock Release Handle,
and the Lowering Handle (which is on the Power Unit).
• Off Side Post: The other Post.
• Power Unit: Provides Hydraulic Fluid to the Lift and connects to an appropriate power source.
Includes the Up Button, the Lowering Handle, and the Hydraulic Fluid reservoir.
• Up Button: Press and hold to raise the Vehicle on the Lift.
• Safety Lock Release Handle: Located on the Power Post above the Power Unit, it
disengages the Safety Locks so you can lower the Lift.
• Power Disconnect Switch: Not supplied. Immediately interrupts main electrical power to the
Lift. Used for electrical circuit faults, emergency situations, or when the Lift is undergoing service or
maintenance.
• Thermal Disconnect Switch: Not supplied. Automatically shuts down the equipment in the
event of an overload or an overheated motor. This equipment is not included with the Lift and must
be installed a licensed Electrician.
• Safety Covers: Cover the Safety Lock Mechanism on the Posts.
• Floor Plates: Cover the Hydraulic Hoses, Equalizing Cables, and Safety Cable being routed to
each Post.
• Lift Heads: Sometimes called Carriages. Lift Heads move up and down in the Posts. They
connect to the Lift Arms, so when the Lift Heads move up, the Lift Arms also move up, thus raising
any Vehicle on the Lift Arms.
• Lift Arms: Extendable steel arms that attach to the Lift Heads. Adapters (also called Pads) attach
at the end of each Lift Arm; they contact the Lifting Points on the underside of the Vehicle.
• Adapters: Pads that contact the Lifting Points on the underside of the Vehicles you raise. Four
60 mm Lift Adapters are included with your Lift. Additional adapters are available separately and
include Frame Cradle Pads, which are well-suited for raising and holding trucks and SUVs (body-
on-frame style).
• Height Adapter Trays: Available separately, attach to the bottom of the Posts, used for holding
the Adapters when not in use.
• Safety Locks: Hold the Lift Heads up when engaged. Multiple Safety Lock heights let you select
the best one for your needs. Once engaged on its Safety Locks, the Lift Heads stay up, even if the
Lift loses power. Only leave your Lift fully lowered or engaged on Safety Locks.
Safety Locks are hidden by the Posts, but you can hear them as the Lift rises. Refer to About
Safety Locks for more information.
• Equalizing Cables: Two Cables that keep the Lift Heads synchronized. You do not want one
Lift Head lowering or raising faster than the other Lift Head; the Equalizing Cables keep them
synchronized. The two Equalizing Cables are the same length.
To Next Page
Loading...
Need help?
General
