BendPak XPR-9 Series User Manual

XPR-9 Series Two-Post Lifts 70 P/N 5900371 — Rev. D2 — May 2023
Troubleshooting
This section describes how to troubleshoot your Lift.
⚠ CAUTION If your Lift is not functioning correctly, you must take it out of service until it is fixed.
Qualified personnel must perform all repair work.
⚠ WARNING The Lift uses electrical energy; if your organization has Lockout/Tagout policies,
make sure to implement them before performing any Troubleshooting.
Issue Action to Take
Once raised, Lift does not lower.
Verify there is sufficient Hydraulic Fluid in the reservoir.
Make sure there is no air in the Hydraulic System.
Make sure none of the Hydraulic Hoses are pinched or leaking.
Make sure the Power Unit is getting electrical power.
If the Hydraulic Fluid is dirty, replace it with clean fluid.
Make sure the Lift is not overloaded. Make sure the load on the
Lift is balanced.
Contact BendPak Support at
bendpak.com/support
, via email at
support@bendpak.com
, or by phone at
(800) 253-2363
,
extension 196.
Lift Head and Arms move
erratically or squeak when in
use.
Move the Lift Head up and down a few times to flush any residual
air from the Hydraulic System.
Lift does not stay up. Make sure to leave the Lift engaged on its Safety Locks.
Check for Hydraulic Fluid leaks.
Vehicle on Lift not level. Make sure Lift is engaged on Safety Locks at the same height.
Make sure the Safety Locks in both Posts are engaged.
If either condition is not met, carefully lower the Vehicle back
down to the ground and raise it again.
Motor not running.
Check connection to power source; make sure it is plugged in
and the appropriate voltage.
Check wiring diagram on Power Unit.
Hydraulic Fluid is dirty.
Replace the dirty Hydraulic Fluid with clean, approved ATF fluids,
such as Dexron III, Dexron VI, Mercon V, Mercon LV, or
comparable.
Lift makes odd noises. Lubricate hinge points using white lithium grease.
If you continue to have issues with your Lift, take the Lift out of service, then contact your dealer or
BendPak Support at bendpak.com/support, via email at support@bendpak.com, or by phone
at (800) 253-2363 select option 7, then 4.

BendPak XPR-9 Series Specifications

General

Brand	BendPak
Model	XPR-9 Series
Category	Lifting Systems
Language	English