XPR-9 Series Two-Post Lifts 68 P/N 5900371 — Rev. D2 — May 2023
Maintenance
⚠ DANGER Before performing any maintenance on your Lift, make sure it is completely
disconnected from power. The Lift uses electrical energy; if your organization has
Lockout/Tagout policies, make sure to implement them before performing any
maintenance. If you come into contact with high voltage/current, you could be
injured or killed.
To maintain your Lift:
• Daily: Keep the Lift clean. Wipe up any spills, remove any dirt or debris.
• Daily: Make a visual inspection of all moving parts and check for damage or excessive wear.
Replace any damaged or worn parts before using the Lift.
⚠ DANGER Do not use the Lift if the cables are damaged or extremely worn. If a Vehicle is
raised when you notice the damage or extreme wear, very carefully lower the
Vehicle to the ground. When the Lift is on the ground, remove it from service,
disconnect it from power, and make arrangements to have it repaired.
• Daily: Make sure Safety Locks are in good operating condition. Do not use your Lift if the Safety
Locks are damaged or excessively worn.
• Weekly: Check all controls to make sure they are functioning normally.
• Weekly: Check all labels on the Lift. Replace them if they are illegible or missing.
• Monthly: Lubricate the Posts. We recommend using white lithium grease or similar.
• Monthly: Check Hydraulic Fluid levels. Refill if low.
• Monthly: Check cable connections, bolts, and pins for proper mounting and torque.
• Monthly: Make sure all pivot arm pins are properly secure.
• Every two months: Check all Anchor Bolts to make sure they are correctly torqued. If they are
not, torque them.
• Every three to five years or as needed. Carefully check the Equalizing Cables every three
to five years, or immediately if there are signs of damage or extreme wear. See Wire Rope
Inspection and Maintenance for additional information.
⚠ WARNING Do not operate your Lift if you find maintenance issues; instead, remove it from
service, then contact your dealer or BendPak Support via the Web at
bendpak.com/support, via email at support@bendpak.com, or by phone at
(800) 253-2363 select option 7, then 4.
To Next Page
Loading...
Need help?
General
