XPR-9 Series Two-Post Lifts 35 P/N 5900371 — Rev. D2 — May 2023
Use the illustrations on the previous page to complete the following procedures below.
To install the Safety Assemblies:
1. Locate the four Safety Assemblies, two Linkage Bars, four Clevis Pins, four Large Pins, and
Torsion Springs.
2. Join the Offside Safety Assemblies (Safety Weldment #2, Safety Weldment #3) using the Linkage
Bar, as shown in the previous illustrations.
3. Join the Power Side Safety Assemblies (Safety Weldment #1, Safety Weldment #3) using the
second Linkage Bar, as shown in the previous illustrations.
The Safety Assembly with the Safety Lock Release Handle must go to the Power Side Post.
4. Starting at the Power Side Post: position the Safety Weldment #1 in place on the Post,
insert the Safety Clevis Pin, from the right, through the hole in the right welded plate in the Power
Side Post, then through the Power Side Safety Weldment, and then through the left welded plate.
5. Position the Torsion Spring on the left end of the Safety Clevis Pin, then install the Hair Pin on the
end of the Safety Clevis Pin.
6. For the Top Safety Assembly, position the Safety Weldment #3 in place on the Post, insert the
Safety Clevis Pin, from the right, through the hole in the right welded plate in the Power Side Post,
then through the Safety Weldment, and through the left welded plate.
7. Install a Hair Pin on the end of the Safety Clevis Pin to secure it in place.
8. Repeat Steps 1 through 7 for the Offside Safety Assemblies on the Offside Post.
To connect the Safety Lock Cable:
1. Starting at the Offside Post, route the loop end of the Safety Cable over the short, lower
Welded Pin (Safety Weldment #2), past the Safety Clevis Pin, and loop it over the right end of the
longer, Welded Pin.
2. Secure a Rotor Clip to the short, lower Welded Pin to keep the Cable in place.
3. Moving to the Power Side Post, screw two Nuts and Washers onto the threaded end of the
Welded Pin with Threads (Safety Weldment.
Verify that one Nut and one Washer is on each side of the opening in the Welded Pin with Threads.
4. Put the non-loop end of the Safety Cable over the front of the Welded Pin and into the holes in the
Welded Pin with Threads, between the two Nuts and the two Washers.
5. Pull any slack out of the Safety Cable, then tighten the Nuts.
⚠ CAUTION When tightening the Nuts, keep tension on the Safety Cable and keep the Safety
Cable centered between the two Nuts.
6. Operate the Safety Lock Release Handle, checking for proper operation of both Safety Assemblies.
⚠ DANGER Verify that both the Power Side and the Offside Safety Assemblies engage properly
before operating the Lift.
To Next Page
Loading...
