BendPak XPR-9 Series User Manual

XPR-9 Series Two-Post Lifts 66 P/N 5900371 — Rev. D2 — May 2023
To raise Lift:
1. Press and hold Up Button.
2. When Lift is just past
desired height, release Up
Button.
3. Press and hold Lowering
Handle.
Do not pull down the Safety
Lock Release Handle. If you
do, the Lift will continue to
lower and will not engage
on its Safety Locks.
Lift engages on its Safety
Locks and stops moving;
release Lowering Handle
when Lift stops.
Only leave Lift on Safety
Locks or fully lowered.
To lower Lift:
1. Press and hold Up Button
for two to three seconds.
This moves Lift off its Safety
Locks.
2. Pull down and hold Safety
Lock Release Handle and
Lowering Handle.
Lift begins lowering.
3. When Lift is fully lowered,
release Safety Lock
Release Handle and
Lowering Handle.
Only leave Lift on Safety
Locks or fully lowered.
Lowering a Vehicle
To lower a Vehicle off the Lift, first raise it a small amount to get it off its Safety Locks, then lower it.
To lower a Vehicle off the Lift:
1. Check under and around the Vehicle to verify the area is clear of all obstructions.
If you find any obstructions, move them out of the way.
2. Press and hold the Up Button for a second or two to move the Lift off its Safety Locks.
Raise the Lift at least two inches to get clear of the Safety Locks.
3. Pull down and hold the Safety Lock Release Handle (on the Power Side Post above and to the
right of the Power Unit).
4. Push and hold the Lowering Handle (on the front of the Power Unit).
Important: Both the Safety Lock Release Handle and the Lowering Handle must be held down
at the same time to lower the Lift.
The Lift begins lowering.
⚠ WARNING Do not override the Lift controls; for safety purposes, they are designed to stop the
Lift if released. Overriding the Lift controls could lead to damage to the Lift, damage
to the Vehicle on the Lift, or injury (even death) to persons near the Lift.
Remain clear of the Lift as it comes down; obey the pinch point warning decals.
5. When the Lift is on the ground, release both Handles, then move all four Lift Arms to their full drive-
through positions.
6. Drive the Vehicle out.

BendPak XPR-9 Series Specifications

General

Brand	BendPak
Model	XPR-9 Series
Category	Lifting Systems
Language	English