Benelli 752S - ABS Button

3 - 8
Instrument and control functions
EN
3
B: The ABS will be active again from any
other previous setting when the button is
pressed for a time longer than 30 secs.
Enabling ABS:
Make sure the motorcycle is stationary
and in neutral. Keep the ABS button pres-
sed for 3-5 seconds, the light will switch
from steady to ashing for about 1.30
seconds (short ashing). Another way for
enabling the ABS system is to switch o
and then on again.
A: the procedure will be ignored by the
system if the ABS button was pressed for a
time ranging from 5 and 30 seconds.
The ABS will keep the current settings.
ABS button
Do not try to adjust settings of ABS while
the motorcycle running. The ABS settings
are not enabled when the vehicle speed is
above 5 km/h.
Disabling ABS
Make sure the motorcycle is stationary
and in neutral. Keep the ABS button pres-
sed for 3-5 seconds, the light will switch
from steady to ashing for about 1.30 se-
conds (short ashing).
At this stage, the ABS system will be not
active and the braking system will con-
tinue working as a normal system not
equipped with ABS.
ABS
~
ABS
~
ABS
~
ABS