6 - 13
Periodic maintenance and adjustment
EN
6
Coolant
The coolant level should be checked befo-
re each ride. In addition, the coolant must
be changed at the intervals specied in
the periodic maintenance and lubrication
chart.
To check the coolant level
Place the vehicle on a at surface and
keep it upright.
TIP
• The coolant level must be checked
on a cold engine since the level va-
ries with engine temperature.
• Make sure that the vehicle is positio-
ned straight up when checking the
coolant level. A slight tilt to the side
can result in a false reading.
Check the coolant level in the coolant re-
servoir.
TIP
The coolant should be between the mini-
mum and maximum level marks.
2. Maximum level mark
3. Minimum level mark
If the coolant is at or below the minimum
level mark, remove the coolant reservoir
cap.
To access the coolant tank, remove the 2
screws and the rubber cover on the igni-
tion lock.
3. Screws (tightening 10 Nm)
4. Rubber seal
Unscrew 2 more screws and remove the
tank xing plate.
5. Screws (tightening 10 Nm)
6. Tank xing plate
2
1
3
4
5
6
To Next Page
Loading...
