Benelli 752S - Air Lter Element; Checking the Engine Idling Speed

Tightening torque:
Coolant drain bolt:
11 N·m
6 - 15
Periodic maintenance and adjustment
EN
6
1. Coolant drain bolt
After the coolant is completely drained,
thoroughly ush the cooling system with
clean tap water.
Install the coolant drain bolt and its new
gasket, and then tighten the bolt to the
specied torque.
Pour the specied amount of the recom-
mended coolant into the radiator and re-
servoir.
Install the coolant reservoir cap.
Install the radiator cap.
Start the engine, let it idle for several mi-
nutes, and then turn it o.
Remove the radiator cap to check the coo-
lant level in the radiator.
If necessary, add sucient coolant until it
reaches the top of the radiator, and then
install the radiator cap.
Check the coolant level in the reservoir.
If necessary, remove the coolant reservo-
ir cap, add coolant to the maximum level
mark, and then install the cap.
Start the engine, and then check the vehi-
cle for coolant leakage.
If coolant is leaking, have a Benelli dealer
check the cooling system.
Air lter element
The air lter element must be replaced
at the intervals specied in the periodic
maintenance and lubrication chart.
Have a Benelli dealer replace the air lter
element.
Checking the engine idling speed
Check the engine idling speed and, if ne-
cessary, have it corrected by a Benelli de-
aler.
Engine idling speed:
1400-1600 r/min.
Antifreeze/water mixture ratio:
1:1
Recommended antifreeze:
High-quality ethylene glycol antifreeze
containing corrosion inhibitors
for aluminum engines
Coolant quantity:
Radiator (including all routes):
2.4 L
Coolant reservoir (up to the maximum
level mark):
0.3 L
1