6 - 2
Periodic maintenance and adjustment
EN
6
Owner’s tool kit
The bike is provided with a tool bag.
The owner’s tool kit is located under the
passenger seat.
The service information included in this
manual and the tools provided in the ow-
ner’s tool kit are intended to assist you in
the performance of preventive mainte-
nance and minor repairs. However, addi-
tional tools such as a torque wrench may
be necessary to perform certain mainte-
nance work correctly.
TIP
If you do not have the tools or experience
required for a particular job, have a Benelli
dealer perform it for you.
A list of workshops is available on our
website www.benelli.com.
TIP
• The annual checks must be perfor-
med every year, except if a kilome-
ter-based maintenance, or for the
UK, a mileage- based maintenance,
is performed instead.
• At the 25.000 km coupon, perform
maintenance operations with the
same intervals indicated in the table.
• Items marked with an asterisk
should be performed by a Benelli
dealer as they require special tools,
data and technical skills.
• The use of non-original replacement
parts may accelerate motorbike
wear and tear and cut shorts its life.
Failure to perform recommended
operations or the use of non-original
parts may render the legal warranty
null and void.
• The replacement and/or topping up
of lubricants and uids, must only be
carried out with the recommended
products.
TIP
AIR FILTER
The air lter needs to be replaced more
often if the vehicle is used in particularly
damp or dusty environments.
HYDRAULIC BRAKE MAINTENANCE
• Check brake uid levels on a regular
basis and top up as necessary.
• Every two years replace the internal
components of the brake master
cylinders and calipers, and change
the brake uid.
• Replace the brake hoses every four
years and if cracked or damaged.
The following section shows all of the
maintenance operations
KEY
I
Inspection and adjustment,
cleaning, lubrication or
replacement, as needed
R Replacement
T
Tighten to the
torque listed
Dealer
To Next Page
Loading...
