Benelli 752S - Page 52

6 - 11
Periodic maintenance and adjustment
EN
6
To change the engine oil (with or wi-
thout oil lter cartridge replacement)
1. Place the vehicle on a at surface and
keep it upright.
2. Start the engine, warm it up for several
minutes, and then turn it o.
3. Place an oil pan under the engine to col-
lect the used oil.
4. Remove the engine oil ller cap, the en-
gine oil drain bolt and its gasket to drain
the oil from the crankcase.
1. Engine oil drain bolt
TIP
Skip steps 5–7 if the oil lter cartridge is
not being replaced.
5. Remove the oil lter cartridge with an
oil lter wrench.
1. Oil lter wrench
2. Oil lter cartridge
TIP
An oil lter wrench is available at a Benelli
dealer.
6. Apply a thin coat of clean engine oil to
the O-ring of the new oil lter cartridge.
TIP
Make sure that the O-ring is properly se-
ated.
7. Install the new oil lter cartridge with
an oil lter wrench, and then tighten it to
the specied torque with a torque wren-
ch.
E
Tightening torque:
Oil lter cartridge:
18 N·m
1
1