Benelli TnT302S - Air Filter Maintenance; Bulb Replacement

TnT302S
44
(1) Over worn sprocket teeth (2) Broken or damaged sprocket teeth (3) Loose sprocket xing nuts
BRAKE
The motorcycle uses a disc brake for both the front brake and the rear brake. Adjustment is nished before
delivery. Contact your dealer if any problems arise.
Brake Fluid
The motorcycle uses DOT4 brake uid. Please replace it every two years.
Don't forget to check the brake uid level in the front and rear brake uid reservoirs. Add appropriate brake uid
if necessary.
Brake pads
Check the front and rear brake pads to ensure they have not been worn to the limit. Replace the pads if worn to the
limit.
MAINTENANCE OF THE AIR FILTER
The air lter should be regularly maintained, especially when driving in areas full of dust and sand.
1. Remove the seat, fuel tank and the side cover.
2. Remove the screws from the air lter cover, remove the air lter cover and remove the lter element.
3. Clean the lter using a foam air lter cleaning spray and allow it to dry completely once clean.
4. Once dry, spray the lter with a foam air lter oil and wring out any excessive oil before reinstallation.
5. Reinstall the components back in reverse order of disassembly.
BULB REPLACEMENT
Replacement of the Head Light Bulb
Remove the bulb cover, replace the old bulb with one of the same specication, and reinstall in reverse order of
disassembly.
INSPECTION BEFORE DRIVING
Notice：
DO NOT use ammable liquids like gasoline or organic solvents to clean the air lter element as they will
cause the foam to deteriorate.