Benelli TnT302S - Throttle Cable Adjustment

TnT302S
39
f. The six sealing plugs on the cover strip align respectively to the six lling ports on the battery. Make sure the
ends of the six sealing plugs have been inserted into the lling ports on the battery; then press down rmly to fully
seat the cover strip until it is ush with the top of the battery.
Once the battery is lled with electrolyte, DO NOT remove the cover strip to add water, electrolyte or any other liquid.
Pay attention to the following matters while replacing the battery:
Before replacing the battery, rst determine the model of motorcycle and check if both batteries are of the same
type. The battery used must be the same as the motorcycle was designed to use it. If a dierent type of battery is
used, it may aect the performance and service life of the motorcycle, and possibly cause an electrical failure.
If the motorcycle will not be used for a long time, remove the battery and charge it once a month.
THROTTLE CABLE ADJUSTMENT
1. Loosen the lock nut. 2. Turn the adjuster to bring the cable adjustment within 10~20mm.
3. Retighten the lock nut after adjustment of the cable clearance.
INSPECTION& MAINTENANCE
Warning：The battery will produce explosive gases when the chemical reaction occurs in it. Keep the
battery away from re, sparks, and high temperature places. The battery is lled with sulphuric acid
(electrolyte). Electrolyte is a poisonous substance.
Please keep it out of the reach of children.