Benelli TnT302S - Page 38

TnT302S
38
c. Turn the electrolyte container upside down and align the six lling ports of the container with the six lling
ports on the battery. Push downward with force on the container so as to puncture the sealing tape on the lling
ports allowing the electrolyte to ow into the battery. Check for bubbles coming up from the battery to ensure
electrolyte is owing into the Battery. Attention: be sure not to tilt the container, or the lling process might be
interrupted.
d. When you are sure that there are bubbles coming up from the battery at multiple ports leave the battery to ll
for 30 minutes.
If there is a port with no bubbles owing up from the battery lightly squeeze or tap the lling container until you
can see bubbles rising from the battery at that port.
e. When the electrolyte container has emptied, tap it several times to ensure that all of the residual electrolyte has
entered the battery; then slowly remove the electrolyte container from the top of the battery using caution to not
spill any drops of electrolyte.
INSPECTION BEFORE DRIVING
Attention:
Please do not tear or puncture the sealing tape on the lling port.
The cover strip can be kept as lling plug for the battery.