Benelli TnT302S - Page 37

TnT302S
37
b. Remove the seat cushion;
c. Remove the mounting bolts and battery retainer bracket;
d. Remove the negative terminal (－) rst, and then the positive terminal (＋);
e. Remove the battery gently.
Install the battery in the reverse order of removal.
Tighten the terminal bolts. Frequently clean the corrosive substances that form on the terminals with a wire brush
while in use. Please operate according to the following requirements while lling electrolyte into the mainte-
nance-free battery:
a. Place the battery vertically on a horizontal surface and remove the sealing tape.
b. Remove the electrolyte from the plastic bag. Remove its cover strip and set it aside to be used it as the
lling plug for the battery.
INSPECTION& MAINTENANCE
Warning：
Correctly connect the battery wires when the battery is being re-installed. The red wire shall be connected
to the positive terminal (＋); and black wire shall be connected to the negative terminal (－). If the wires
are incorrectly connected, it may damage the electrical system and the battery.
The ignition switch (key) shall be shut o while inspecting or replacing the battery.