IMPORTANT REMINDER
5
TnT302S
Warning: This motorcycle must be equipped with a fuse of the same specication as stock to ensure safe opera-
tion. Use of fuses of the wrong specication is strictly prohibited. Use of incorrect fuses or non fuse objects could
result in sparks, re or even electrocution.
Location of the fuse: next to the battery.
A blown fuse is usually caused by an electrical system fault. Look over the vehicle any time a fuse has blown and
needs to be replaced before installing it. If the fuse blows immediately when installed do not attempt to replace it
again and do not replace the fuse with a non fuse object like wire. Take your vehicle to an authorized Benelli
dealership for inspection and repair and only operate it once the situation is resolved.
Notes:
Before changing the fuse, switch the key to " " in case of short circuit;
* Make sure the contact point of the fuse is not broken while changing the fuse, which would result in bad
contact, parts damage, and even re.
Do not recongure the motorcycle or change the locations of the parts and accessories at will, this will cause a
strong impact on the stability and safety of the motorcycle, and may cause operational faults. Modications
performed to the electrical system, emission control system, canister, or any other components are prohibited and
will violate the riding safety and trac administration regulations. Any and all problems arising from unauthorized
modications of this vehicle will become the responsibility of the user. The user shall obey all local regulations and
trac safety laws.
To Next Page
Loading...
Need help?
General
