24
Engine Run-o
It is used to switch o the engine in an emergency. The ignition circuit is disabled, preventing the engine from being
restarted. To be able to restart the engine, return the switch to the "ON" position.
CAUTION
Under normal conditions, do not use this switch to shut o the engine.
Front brake lever
It controls a hydraulic circuit that operates the front wheel braking system.
CAUTION
To avoid damaging the electrical equipment, be sure not to hold down the button for longer
than 5 consecutive seconds. If, after some attempts, the engine does not start, contact your
Authorized Benelli Service Center.
Throttle twist grip
It controls the fuel-air mixture supplied to the engine, which regulates engine speed.
To increase engine speed, rotate the hand grip from its idle position counterclockwise.
Engine start button
This device permits the motor starting, by the steering clutch , if it is used 3 seconds after the motor starting, you can
use the display functions.
To Next Page
Loading...
