Benelli TRE-K899 - Motorcycle Cleaning

90
Cleaning the motorcycle
6.14
Periodic careful cleaning is a key factor in preserving the value of the motorcycle, protecting its surface nish and
checking for damages, wear and leakage of corrosive uids.
Wash the motorcycle with water, a mild detergent and a sponge.
Wipe the vehicle with a soft cloth.
Use an air jet to dry dicult-to-reach areas.
Periodically treat the paintwork with high quality wax. After riding on roads treated with corrosive substances (salt),
wash the vehicle as soon as possible with cold water. Do not use hot water as it enhances the corrosive action.
WARNING
Do not wash your motorcycle soon afterwards riding.
Attend a few minutes to allow the engine and the exhaust pipes to thoroughly cool.
Before washing the vehicle, stop up the exhaust pipes and protect the electrical parts.
Never use washing systems involving steam or high pressure water jets.
These systems could cause water inltration and damage the internal parts of your motorcycle.
Avoid cleaning the rims with fuel or solvents. Avoid using clothes or sponges that have been in
contact with strong or abrasive detergents, solvents or gasoline.
To avoid irreparable damage to the front fairing, never use alkaline or strongly acid detergents,
petrol, brake uid or other solvents.
Clean the front fairing only with a soft cloth, warm water and a neutral detergent.