Benelli TRE-K899 - Page 83

79
Check the pressure according to the values indicated in the table below:
PRESSURE
Front cool tyre
Back cool tyre
222 kPa (2,2 Bar)
242 kPa (2,4 Bar)
In the event of long travels, you can increase the face value of the tyre pressure of 0.2 Bar.
It is extremely important to check the wear of the tyres before riding. In fact, a worn out tyre can be punctured more
easily than a new one, and it can adversely aect handling and stability of the motorcycle.
Check that the depth of the tyre tread is not below the values prescribed by the Highway Code.
Verify the absence of crevices at the bottom of the tread design and ssures on the tyre sidewall.
Moreover, verify the absence of nails and glass splinters in the tyre.
If these conditions are not veried, have the tyre replaced by an Authorized Benelli dealer.
DANGER
If a tyre is punctured it must be replaced, not repaired. A repaired tyre provides a restricted
performance and lower safety levels than a new one. If you make a provisional or emergency
repair to a tyre, you must ride at very low speed until you reach the nearest Benelli Authorized
service center and have the tyre replaced. After a tyre is temporarily repaired and used for
emergency purposes, never exceed 60 km/h (37.2 mph). Tyre repairing must never be
performed if the tyre is punctured on its sidewall, or if the diameter of the puncture on the tread
is greater than 6 mm (0.23 in). When it is necessary to replace the tyres, use only the type
specied in the technical data table. Moreover, avoid using tyres of a dierent brand or type on
the front and on the rear wheel at the same time. Using tyres dierent from those