12/ 2017
BENNING PV 2
28
9. Maintenance
c
Before opening the BENNING PV 2, make quite sure that it is voltage free!
Electrical danger!
Work on the opened BENNING PV 2 under voltage may be carried out only by skilled
electricians with special precautions for the prevention of accidents.
Make the BENNING PV 2 voltage free as follows before opening the instrument:
- Switch the tester off.
- Remove all connecting cables from the object.
9.1 Error codes
Error codes Remedy
The internal fuse has blown, see chapter 9.5 "Fuse re-
placement"
The electronic components of the BENNING PV 2 have
reached the maximum admissible temperature. Discon-
nect the BENNING PV 2 from the object to be measured
and let it cool down.
The DC short-circuit current exceeds the maximum value
of 15 A. Measurement has been stopped.
The DC open circuit voltage has exceeded the maximum
value of 1000 V. The measurement has been stopped.
The DC power has exceeded the maximum value of
10 kW. Measurement has been cancelled.
Immediately disconnect the BENNING PV 2 from the PV
generator!
Please return the BENNING PV 2 to an authorized service
center, see chapter 9.6 "Calibration" for the address.
Please return the BENNING PV 2 to an authorized service
center, see chapter 9.6 "Calibration" for the address.
Please return the BENNING PV 2 to an authorized service
center, see chapter 9.6 "Calibration" for the address.
oder
Please return the BENNING PV 2 to an authorized service
center, see chapter 9.6 "Calibration" for the address.
etc.
Please return the BENNING PV 2 to an authorized service
center, see chapter 9.6 "Calibration" for the address.
The BENNING PV 2 is not correctly calibrated, see chap-
ter 9.6 "Calibration".
Storage has failed. Please store the measured values
again to the next storage location available.
To Next Page
Loading...
