Need help?Do you have a question about the Benning IT 130 and is the answer not in the manual?
General| Loop/Line Impedance | Yes |
|---|---|
| Insulation Resistance | Yes |
| Continuity Testing | Yes |
| Voltage Measurement | Yes |
| Phase Sequence | Yes |
| Display | LCD |
| Standards | IEC/EN 61557, IEC/EN 61010 |
| Power Supply | Battery |
General warnings and precautions for safe use of the tester.
Explains display indicators, connection monitor, and warning signals.
How to measure voltage, frequency, and phase sequence.
Explains how to perform and interpret insulating resistance tests.
Covers low-impedance and continuity testing procedures.
Details testing procedures for residual current devices (RCDs).
How to measure loop impedance and calculate short-circuit current.
Explains measurement of line impedance and voltage drop.
Describes performing earthing resistance measurements.
How to test for correct PE conductor connection and reversed wiring.
Measurement of single-fault leakage current in IT networks.
Steps for saving measurement results to the tester's memory.
How to retrieve previously saved measurement results.
General data and specifications related to RCD testing.
To Next Page
