Benning IT 130 - Commander ON;OFF; Initial Settings

BENNING IT 130 Measurements
- 29 -
4.4.7 Commander ON/OFF
In this menu, it is possible to enable or disable
the "Commander" (switchable test probe).
Figure 4.10:
Selecting the "Commander" support
Keys used:
UP / DOWN
Selects Commander ON (enabled) / Commander OFF (disabled)
TEST
Confirms the selected option
ESC
Back / cancel to the Settings menu
Function selector switch
Back / cancel to the selected measuring function
Note:
 The "Commander OFF" (disabled) option is intended for deactivating the operating keys
of the "Commander" (except for the background lighting key). It is useful to disable the
"Commander", if strong sources of interference might affect the correct functioning of the
"Commander".
4.4.8 Initial settings
In this menu, it is possible to reset the settings,
measuring parameters and limiting values of the
installation tester to their initial (factory) settings.
Figure 4.11:
Initial settings dialog
Keys used:
UP / DOWN
Selects the option [YES, NO]
TEST
Confirms the selected option
ESC
Back / cancel to the Settings menu
Function selector
switch
Back / cancel to the selected measuring function
Note:
 If the tester is reset to its initial (factory) settings, all settings made will be lost!
 If the batteries are removed for more than 1 minute, all settings made will be lost.
The initial (factory) settings are defined as follows:
Settings of the tester Default setting
Language German
Contrast 50 %
Earthing system TN / TT
Isc factor 1.00
RCD standards EN 60364-4-41
"Commander" test probe ON
Current clamp settings BENNING CC 3