Operation
46
Shutting down the projector
1. Press on the projector. A confirmation
message displays prompting you.
If you don't respond in a few seconds, the
message will disappear. If you use the remote
control, press to shut down the projector.
2. Press on the projector a second time. The
POWER indicator light flashes orange, the
projection lamp shuts down, and the fans will
continue to run to cool down the projector.
To protect the lamp, the projector will not respond to
any commands during the cooling process.
3. Once the cooling process finishes, the
POWER indicator light is a steady orange
and fans stop.
4. Disconnect the power cord from the power putlet if the projector will not be used
in an extended period of time.
• If the projector is not properly shut down, to protect the lamp, when you attempt to re-start
the projector, the fans will run for a few minutes to cool down. Press Power again to start
the projector after the fans stop and the POWER indicator light turns orange.
• Actual lamp lives may vary due to different environmental conditions and usage.
Direct power off
The AC power cord can be pulled out right after the projector is turned off. To protect
the lamp, wait about 10 minutes before re-starting the projector. (When you attempt to
re-start the projector, the fans may run for a few minutes to cool down. In such cases,
press again to start the projector after the fans stop and the POWER indicator light
turns orange.
I
I
I
I
I
I
I
I
To Next Page
Loading...
