Operation
57
FUNCTION DESCRIPTION
Test Pattern
Selecting On enables the function and the projector displays the grid
test pattern. It helps you adjust the image size and focus and check
that the projected image is free from distortion.
Closed
Caption
Closed Caption Enable
Activates the function by selecting On when the selected input signal
carries closed captions.
• Captions: An on-screen display of the dialogue, narration, and
sound effects of TV programs and videos that are closed
captioned (usually marked as "CC" in TV listings).
Caption Version
Selects a preferred closed captioning mode. To view captions, select
CC1, CC2, CC3, or CC4 (CC1 displays captions in the primary
language in your area).
Standby
Settings
Monitor Out
Selecting On enables the function. The projector can output a VGA
signal when it is in standby mode and the COMPUTER IN-1 and
MONITOR-OUT jacks are correctly connected to devices. See
"Connecting a monitor" on page 20 for how to make the connection.
Audio Pass Through
The projector can play sound when it is in standby mode and the cor-
responding jacks are correctly connected to devices. Press / to
choose the source that you wish to use. When you select Computer
1 or Computer 2, audio signal can only be fed into the AUDIO-IN 1
or AUDIO-IN 2 jack. When you select Video,S-Video, audio signal
can only be fed into the AUDIO-IN L/R jacks. There is no need to
connect the audio cable when HDMI is selected since the HDMI cable
carries audio signal.
Network
Selecting On enables the function, and the projector can be moni-
tored or controlled over a network when it is in standby mode.
Enabling this function slightly increases the standby power
consumption.
The Monitor Out only works when an appropriate D-Sub input is
made to the COMPUTER IN-1 jack.
Network
Settings
Wired LAN
See "Controlling the projector through a LAN environment" on page
42 for details.
AMX Device Discovery
Selecting On enables the function. When AMX Device Discovery is
On, the projector can be detected by AMX controller.
Mac Address
Displays the mac adress of this projector.
Reset All
Settings
Returns all settings to the factory preset values.
The following settings will still remain: Position, Phase, H. Size,
User 1, User 2, Projector Position, Color Space Conversion, High
Altitude Mode, Security Settings, Baud Rate and Network Settings.
5. SYSTEM SETUP: Advanced menu
To Next Page
Loading...
