The OSD (On-Screen Display) menu 47
Film mode Turns on or off the film mode frame conversion function.
• Auto - Enable the film mode frame conversion function for movies and
motion pictures. The display converts a 24 frames-per-second (24 fps)
input signal format into DVD video signal format. Once this function is
enabled, we recommend that you set the Scan conversion function to
Progressive.
• Off - Disable the film mode frame conversion function. This mode is
suitable for TV broadcasting and VCR signals.
For Component and HDMI (video mode) inputs only.
IR control Sets the operation mode of the remote control when multiple units are
connected via RS-232C cables.
• Normal - All units can be operated normally by the remote control.
• Primary - Designate this display as the primary unit for remote control
operation. Only this display will be operated by the remote control.
• Secondary - Designate this display as the secondary unit. This display
cannot be operated by the remote control, and will only receive the
control signal from the primary unit via the RS-232C connection.
• Lock - Lock the remote control function of this display. To unlock, press
and hold the INFO button on the remote control for 5 seconds.
IR out To operate multiple units with one IR remote control, select Enable.
Point the remote control to the first display which IR OUT port connects
to the second display’s IR IN port, and the second display’s IR OUT port
connects to the third display’s IR IN port, and so on.
See Connecting multiple displays on page 23 for connection diagram.
Keyboard
control
Sets the function of the keyboard (control buttons) on the display.
Tiling With this function you can create a single large screen matrix (display wall)
that consists of up to 25 displays (5 units on the vertical side and 5 units
on the horizontal side). This requires you to connect each unit in a daisy-
chain configuration.
• H monitors/V monitors - Sets the number of displays used in the
horizontal/vertical position.
• Position - Sets the position of this display in the screen matrix. Position
is defined by the total number of displays in the video wall counting from
the top, left hand display and counting horizontally. The number is then
continued on the next row down, and the procedure is continued until
the final display is reached.
• Frame comp. - Adjusts images near the display edges for optimal
demonstration across the display wall.
• Enable: Choose to enable or disable the Tiling function. If enabled, the
display will apply the settings in H monitors, V monitors, Position,
and Frame comp..
• Switch on delay: Choose to enable or disable a sequence in turning on
the screen matrix. If enabled, the display will turn on one horizontal
matrix at a time starting from the top row.
To Next Page
Loading...
