Operation28
Changing Color Space
In the unlikely event that you connect the projector to a DVD player via the projector’s
HDMI/MHL or HDMI input and the projected picture displays wrong colors, please
change the color space to YUV.
To d o t h i s :
1. Press MENU/EXIT and then press / until the SOURCE menu is highlighted.
2. Press to highlight Color Space Conversion and press / to select a suitable
color space.
This function is only available when the HDMI/HML or HDMI input port is in use.
Magnifying and searching for details
If you need to find the details on the projected picture, magnify the picture. Use the
direction arrow keys for navigating the picture.
• Using the remote control
1. Press ZOOM+/ZOOM- or Digital Zoom+/Digital Zoom- to display the Zoom
bar. Press ZOOM+ or Digital Zoom+ to magnify the center of the picture. Press
the key repeatedly until the picture size is suitable for your need.
2. Use the directional arrows ( , , , ) on the projector or remote control to
navigate the picture.
3. To restore the picture to its original size, press AUTO. You can also press ZOOM-
or Digital Zoom-. When the key is pressed again, the picture is further reduced
until it is restored to the original size.
• Using the OSD menu
1. Press MENU/EXIT and then press / until the DISPLAY menu is highlighted.
2. Press
to highlight Digital Zoom and press MODE/ENTER. The Zoom bar
displays.
3. Press repeatedly to magnify the picture to a desired size.
4. To navigate the picture, press MODE/ENTER to switch to the panning mode and
press the directional arrows ( , , , ) on the projector or remote control to
navigate the picture.
5. To reduce size of the picture, press MODE/ENTER to switch back to the zoom in/
out function, and press AUTO to restore the picture to its original size. You can
also press repeatedly until it is restored to the original size.
The picture can only be navigated after it is magnified. You can further magnify the picture while searching for
details.
To Next Page
Loading...
