Bentel Security B3G-220 - Page 47

220 Series 47
 Voice Messages: select the voice messages to be sent in response to the event: you can select up to three voice messages
per event (First Message, Second Message and Third Message); click on [...] to browse the list of messages; you can
select a pre-recorded message (see Voice Messages) or record a new one, or open a .wav file on the PC.
 SMS Tel. Numbers: select the numbers to which an SMS is to be sent.
 The phone numbers are those selected in the line SMS Phone Numbers.
 SMS Text: enter the text to be sent when the event occurs (up to 70 characters).
Central Station Calls
The following options is related to digital event reporting to the central station.
Periodic Call
 Periodic Test Transmission Interval: set the interval (Days and Hours) between two Periodic Test Transmissions
events. Range: 0 to 365 days and 0 to 23 hours.
 Periodic Test Transmission First Send: set the date and time of the first Periodic Test Transmission event.
The 24hr/12hr button allows you to select the time display format: 12 hour or 24 hour.
The Now button sets the PC's current time.
SIA
 Date/Time on SIA packet: if enabled, the SIA packet will include the date and time.
Phone Number Use
This table specifies which numbers in the Phonebook are to be used for sending digital messages, when Channel Type is set
to CID: Over GSM: up to 8 numbers can be set.
 When you select Channel Type, CID/SIA: over Data Network, the events are transmitted to the IP receivers indicated
in the IP Receivers page.
Events—Actions
This table specifies, for each event handled by the communicator, the digital messages to send to the numbers specified in the
table Phone Number Use.
 Label: this column lists the events for which a digital message is to be sent.
 Customer code: enter the user code (4 hex characters).
 You can set a different Customer code for each Input Event, or a single Customer code for all other events.
DO NOT use the character “A” for Contact ID.
 Contact ID Identifier: enter the Contact ID the communicator is to send for the event.
 The communicator also sends the qualifier 1 when the event occurs and the qualifier 3 when it terminates, as required by the
Contact ID protocol.
 Event SIA Identifier: enter the SIA code the communicator is to send when the event OCCURS.
 Restore SIA Identifier: enter the SIA code the communicator is to send when the event TERMINATES.
 Channel Type: select CID: Over GSM to send the event with the Contact ID protocol using a voice call on GSM; select
CID/SIA: over Data to send the event with the Contact ID or SIA protocol on the cellular network (the protocol will be the
one selected in the Communication Protocol option in the Options page).
 Event Enabled: select Disabled to NOT send the event; select Send Activation to send ONLY the event's occurrence;
select Send Restoral to send ONLY the event's restoral; select Send Activation and Restoral to send both.