48 Universal Cellular Communicator
Telephone Numbers: select the numbers to which the event is to send the digital message, when you have selected Channel
Type, CID: Over GSM.
When you select Channel Type, CID/SIA: over Data Network, the events are transmitted to the IP receivers indicated
in the IP Receivers page.
The phone numbers are those selected in the Phone Number Use table.
CID/SIA Converter
If the communicator detects that the panel connected to the LI terminals is dialing a number from the Phonebook with the option
CID/SIA Event Conversion enabled, it converts the panel's Contact ID or SIA message into a voice or SMS message,
as indicated in this page.
Phone Number Use
This table specifies which numbers in the Phonebook are to be used for sending SMS (SMS Phone Numbers) and voice
messages (Voice Dialer Phone Numbers): you can choose up to 8 numbers for each option.
Events—Actions
Label: this column lists the events for which a voice or SMS message is to be sent.
Contact ID Identifier: set whether the event to be converted is an Activation or Restore; set the type of event
(e.g. 130 - Burglary); select the partition of the event; select the zone of the event.
This option is considered only if Contact ID has been selected as Communication Protocol in the Options page.
Event SIA Identifier: enter the SIA event identifier to be converted.
This option is considered only if SIA has been selected as Communication Protocol in the Options page.
SMS Tel. Numbers: select the numbers to which an SMS must be sent.
The phone numbers are those selected in the line SMS Phone Numbers.
SMS Text: enter the message to be sent when the event occurs (up to 70 characters).
Voice Messages: select the voice messages to be sent when the event occurs: you can select up to three voice messages
for each event (First Message, Second Message and Third Message); click on [...] to browse the list of messages; you
can select a pre-recorded message (see Voice Messages) or record a new one, or open a .wav file on the PC.
Telephone Numbers: select the numbers to which the event is to send a voice message.
The phone numbers are those selected in the line Voice Dialer Phone Numbers.
To Next Page
Loading...
