Bentel Omnia 4 - User Menu Options from keypad; Reset Alarm Memory

User Menu Options from keypad
<Code PIN>+
Only Main User Code PINs have full access to all the options. User Code PINs
can access two options only: Reset Alarm Memory and Overtime Request.
To access options:
1. Enter a Main User or User Code PIN.
2.
Press .
3. Select the required option.
Options from__
keypad__
r Reset Alarm Memory
r Enable / Disable auto arming
r Enable / Disable Teleservice
r Overtime Request
r Teleservice Request
r Enable / Disable Silent option
r Enable / Disable hidden zone status on keypad
r Alarm Device Test
r Code PIN Programming
r Stop Alarms
r Stop Calls
+
The Options will affect the partitions controlled by the Code PIN and key-
pad in use.
Reset Alarm Memory
<Code PIN>+ +
All zone alarms are recorded in the alarm memory. The Reset Alarm Mem-
ory option erases the alarm memory, and forces the Alarm Signalling De-
vices (connected to the alarm outputs) of the partitions controlled by the
Code PIN into standby status.
To Reset Alarm Memory:
1. Enter a Main User or User Code PIN.
2.
Press .
3.
Press .
+
Only Main User Code PINs can Reset the System Tamper Alarm Memory.
ATTENTION The Control panel will effect Reset Alarm Memory each
time the control panel is armed, that is, if so programmed by the Installer.
18 Security System Control Panels Omnia8/Omnia4