Superkeys
Each Superkey controls a specific command. Superkeys commands do not
require Code PINs.
Press key , , , or for approximately 4 seconds. The se-
lected key will take on Superkey status, and the assigned command will be
activated.
COMMAND SUPERKEY
Activate Instant alarm call on the
Digital Communicator and Dialler
,
View alarm memory
,
Trouble Viewing mode
Instant alarm call
Superkeys , ,
Events corresponding to superkeys , and must be programmed
by the installer. The 3 alarm types (Fire, Danger and Police Request) can
each be assigned to a specific Event Call. The required Event call can be
activated from the keypad by pressing the corresponding key for approxi-
mately 4 seconds. The icon on the key identifies the alarm type.
Fire alarm Danger alarm Police
A long high-tone beep will confirm command acceptance. The Digital Com-
municator and Dialler will be activated shortly after.
View Alarm Memory
Superkey
To view the alarm memory:
Press key for approximately 4 seconds.
A long high-tone beep will confirm command acceptance.
Any alarm and / or tamper events which may occur after Reset Alarm
Memory will be shown on keys through (corresponding to the
zones), as follows:
----ON indicates alarm memory on the corresponding zone
----Slow flashing indicates tamper memory on the corresponding zone
----Fast flashing indicates alarm and tamper memory on the corresponding
zone
CONTROL FROM KEYPAD 23
To Next Page
Loading...
