INDICATOR TROUBLE VIEWING MODE
Key 1
OFF:
ON:
Sensor power protection fuse intact
Sensor power protection fuse blown
Key 4
OFF:
ON:
Main Unit powered by mains
Mains failure: Main Unit powered by battery
Key 7
OFF:
ON:
Battery charged
Low battery or battery trouble
Key A
OFF:
ON:
Communication bus normal
Communication bus trouble
Key 0
OFF:
ON:
Telephone line OK
Telephone line trouble
Number Keys
In standby status ----the LEDs behind number keys through (corre-
sponding respectively to the zones) will show the zone status:
----OFF indicates zone in standby status
----Slow flashing indicates alarm or tamper memorized on the zone
----Fast flashing indicates zone violation (alarm or tamper)
Buzzer The audible signals emitted by the Keypad buzzer are as follows:
----Key pressed = Short beep
----Command accepted = Long high-tone beep
----Error signal = Long low-tone beep
The buzzer can also signal the elapsing Entry / Exit delay.
Codes 23 Codes are available for the user. The Installer can assign one of the 5
Code Types: - DISABLED - MAIN USER - USER - DURESS - PATROL to
each of the 23 codes. Each code can control specific options and partitions
according to programming. Main User Type codes can assign a 4 to 6 digit
PIN to the other Code Types. When a Code PIN is entered on a keypad it
can enable / disable the options on the partitions it can control, and on the
partitions of the keypad in use. Code errors will be signalled by a Long low-
tone beep, after which it will be possible to retry.
r MAIN USER Codes provide full control of the system options, and can ac-
cess the programming phase and change the User Code PINs, therefore,
should be given to persons that require full control of the system.
r USER Codes are enabled for Global arming / disarming, Reset Alarm
Memory and Overtime requests. These Codes allow restricted control of
the system, therefore, should be given to persons that do not require full
control of the system.
r DURESS Codes are for forced disarming (disarming under threat). Entry of
a Duress Code PIN will disarm the system and activate the Digital Commu-
nicator (which will send an alarm call to the Central Station), and dialler
(which will send the recorded voice messages to the programmed tele-
phone numbers).
8 Security System Control Panels Omnia8/Omnia4
To Next Page
Loading...
