32
Bentone
165 105 11
8. Replacement of electrical components
1. Switch off the main power.
2. Note the connection of the existing component.
3. Remove the existing component.
4. Install the new component using the same wiring as the existing
component or the specified alternative arrangement.
5. Turn on the main power.
6. Check the function of the new component.
7. Start the burner. Check combustion.
!
If the burner is directly connected, ensure that all
components on the burner are without power.
!
When servicing/replacing components that affect combustion, an analysis and
soot test shall be carried out on the installation.
To Next Page
Loading...
