17.2. Software KEYSOFT
The software KEYSOFT permits transfer of parameter values from KEY to the PC and vice versa.
Data can be saved on the PC.
System requirements:
• Personal computer AT-compatible with serial interface RS 232 (COM1 or COM2).
• Operating system DOS 3.21 or higher.
• The software KEYSOFT is supplied together with an interface converter which permits
conversion of the data between RS 232 and RS 485.
Operation of the software is described in a separate manual.
17.3. Telecomander RC
The telecomander RC allows to remote control up to 15 inverters connected on the same RS485
bus. After selection all functions of the inverter can be controlled and saved by way of the
telecomander keypad.
17.4. DVM - PLUS MP
Multifunctional device with a 2 lines display (visualization programmable). When is linked to the
inverter by the RS485 interface, it is permitted to access all the inverter functions and to use the
motorpotentiometer function.
17.5. ACM - Synchronizer
The ACM - Synchronizer furnished the number of revolutions and the rotation sens of a motor wich
isn’ t under voltage at the measurement moment. A ACM-D2 inverter linked with the motor and
helped by these informations is able to rotate directly with the speed of the motor.
BERGES electronic
54 Operating manual ACM-D2 29.05.98
To Next Page
Loading...