2. Use of the inverter in accordance with its intended
purpose
The application of the inverter described in this operating manual exclusively serves the purpose of
continuously variable speed control of three-phase motors.
The inverter are designed for installation in a switch gear cabinet and for permanent connection.
The operator of the system is solely liable for damage resulting from improper use of the inverter.
The operator of the system is responsible for obeying the operating, maintenance and repair conditions.
Only personnel informed about the functions and hazards of the inverter may be employed for the
purposes of operation, maintenance and repair.
Only items expressly approved by BERGES (e.g. mains filters and chokes etc.) may be used as
accessories.
The installer of the system is liable for any damage resulting from the use of accessories that have not
been approved expressly by BERGES. Please consult us in the event of uncertainty.
Before you continue reading, please check whether technical amendments are attached
in the annex to this operating manual!
3. Introduction
The present operating manual contains specifications, installation instructions and troubleshooting
procedures for ACM-D2 inverters.
The information in this manual must be known before installation of the inverter in order to guarantee
fault-free installation and thus maximum performance.
The information contained in this manual refers to the software versions D2A-STD-014 and
D2A-1300-012.
BERGES electronic
29.05.98 Operating manual ACM-D2 5
To Next Page
Loading...