unnecessary amount of movement before initiating vibrato, and with the setting
too low the natural sensor noise will cause MIDI chatter around zero. To find the
right setting, use a MIDI monitor software on your computer or other device. It
should not be showing pitch bend activity when idle. When you are pleased
with the setting, press ENTER or MENU to save it. Setting values go from 1 to
30, where 10 is the factory default.
SETUP CTR – EXCT CC A
The extra controller (lip sensor and/or touch pad) can be disabled or set to
control transmission of selected MIDI CC data.
OFF – Extra controller is disabled.
MW – Mod Wheel (CC#1) data is sent. Disabled if breath data is sent over CC#1.
FP – Foot Pedal (CC#4) data is sent. Growl on some synth patches. (default)
CF – Filter Cutoff (CC#74) data is sent.
SP – Sustain pedal (CC#64). Holds fingered notes until controller is released.
SETUP CTR – EXCT CC B
Secondary CC value to be sent with extra controller. Can be sent together
with main CC for extra controller, or switched using mod key (see mod key
settings). Values from 1 to 127. Default OFF.
SETUP CTR – EXCT HARM
To use the lip sensor extra controller for going through the harmonic series,
set this to the range you want. A larger range makes it harder to control, as the
To Next Page
Loading...
Need help?
General