8
5 ELECTRICAL COMMISSIONING
5.1 Opening/Closing electrical compartment
You need to open the electrical
compartment to wire the actuator.
Position indicator option
If the closing direction is not standard
(clockwise), please configure the
position indicator accordingly
(see § 5.4) if this operation has not
already been performed.
How to open electrical
compartment
1. With a 10 mm angled socket
wrench or a flat blade screwdriver loosen the 4 screws.
2. Remove the cover along the axis of the position indicator
(see § 5.2).
How to close electrical compartment
1. Position the cover with the indicator window opposite the
position indicator.
2. Insert the cover on the position indicator until it reaches the
housing.
3. With a 10 mm angled socket wrench or a flat blade
screwdriver, tighten the 4 screws on the housing.
To Next Page
Loading...
