Bernette Funlock B42 - Page 18

 17
8
7
6
9
10
11
11
C
10
D
B
A
4
5
8
7
6
9
10
11
11
C
10
D
B
A
4
5
8
7
6
9
10
11
11
C
10
D
B
A
4
5
– Turn the hand wheel toward you until the
chainstitch looper extends out 10mm from the
needle plate edge.
– Thread the looper area of the machine following
the violet color–coded thread guides (4)–(11).
– Place the thread with the point of the tweezers
through threading guide (4).
– Place the thread with the point of the tweezers
through the front slot of threading guide (5).
– Place the thread with the point of the tweezers
through threading guide (6-9).
– Thread the looper eye (A) from front to back.
– Pull about 10 cm (4 inches) of thread through
the looper.
– Position thread into V cutout (B) on threader.
– Firmly hold thread tail with left hand and pull
Threader lever (C) up into place (D).
PLEASE NOTE:
Use of tweezers in the looper cover will make
needle eye threading easy.