Bernette Funlock B42 - Page 22

 21
6
7
8
10
5
4
9
3
1
2
2
3
2
3
4
1
1
2
2
5
6
7
8
9
10
10
9
– Continue to thread points (4)–(9)
– Before threading eye of needle, make sure
thread is in front of thread guide located on the
bottom of Needle holder for Coverstitch.
– Thread the eye of the middle needle (10).
PLEASE NOTE:
Slide thread into middle slot on thread guide (5).
Slip the thread into the slot of the Take–up Lever
Cover (6).
Slip the thread into the middle slots for thread
guides (7-9).
PLEASE NOTE:
Use of tweezers in the looper cover will make
needle eye threading easy.
– Draw about 10 cm (4 inches) of thread through
needle eye towards the rear of the machine.
– Place the thread to the back, under the presser
foot.