Setting up the sewing computer
14
Inserting the bobbin
... it lies in the T-shaped slit at
the end of the spring.
The bobbin must turn clock-
wise when thread is pulled.
Insert the bobbin
Insert the bobbin so that the
thread runs clockwise.
Pull the thread counter clock-
wise into the slot.
Pull the thread to the left under
the spring until ...
Removing the needle
•
raise the needle
•
turn power switch to «0»
•
lower the presser foot
•
loosen the needle clamp screw
•
pull the needle down to remove
Inserting the needle
•
flat side of needle to the back
•
insert the needle as far as it will go
•
tighten the needle clamp screw
Changing the needle
Please refer to the
safety instruction!
To Next Page
Loading...
